SV5 1 L
MARABU GmbH & Co KG
SV5 1 L is a solvent mixture of esters and ketones used as a printing auxiliary. It presents acute toxicity hazards through ingestion, skin contact, and inhalation, and causes serious eye damage. The product requires proper ventilation during handling and suitable personal protective equipment to minimize exposure risks.
Hazard Pictograms
ghs07
ghs05112-07-2,96-48-0
English
GHS/CLP
30 September 2015
Request This SDS
Safety Information
Key safety data extracted from the official Safety Data Sheet
Key Hazards
Danger- Causes serious eye damage
- Harmful if swallowed, in contact with skin, or if inhaled
- May cause drowsiness or dizziness with excessive vapor exposure
- Contains 2-butoxyethyl acetate (74-94%) and gamma-butyrolactone (10-20%) as hazardous ingredients
- Vapors are heavier than air and may form explosive mixtures
First Aid Quick Guide
Remove contact lenses and rinse copiously with clean, fresh water for at least 10 minutes while holding eyelids apart. Seek immediate medical advice.
Remove contaminated clothing. Wash skin thoroughly with soap and water or use recognized skin cleanser. Do not use solvents or thinners.
Remove to fresh air and keep patient warm and at rest. If breathing is irregular or stopped, administer artificial respiration. Seek medical attention if symptoms persist.
Rinse mouth with plenty of water if conscious. Do not induce vomiting. Obtain immediate medical attention and keep at rest.
Protection Needed
Use full mask respirators with filter A if workers are exposed to concentrations above the exposure limit of 20 ppm(V). Local exhaust ventilation recommended to maintain concentrations below the occupational exposure limit.
Nitrile rubber gloves with textile undergloves required for prolonged or repeated handling. Material thickness greater than 0.5 mm with breakthrough time less than 30 minutes. Replace regularly if damaged.
Safety eyewear designed to protect against splash of liquids
Cotton or cotton/synthetic overalls or coveralls normally suitable to prevent direct contact with the mixture
Physical Properties
Safe Handling
- Prevent creation of flammable or explosive vapor concentrations and avoid exceeding occupational exposure limits
- Use only in areas with all naked lights and ignition sources excluded and appropriate electrical equipment protection
- Always use earthing leads when transferring between containers and wear anti-static clothing and footwear
- Avoid skin and eye contact; avoid inhalation of particulates and spray mist
- Keep containers tightly closed and never use pressure to empty non-pressure vessels
Store between 15 and 30°C in a dry, well-ventilated place away from sources of heat and direct sunlight. Keep containers tightly closed and away from ignition sources. Store away from oxidizing agents and strongly alkaline or acidic materials. Prevent unauthorized access.
Disclaimer: The information displayed on this page is derived from the manufacturer's Safety Data Sheet. Always refer to the official SDS document for complete and up-to-date safety information. Sevron is not responsible for any inaccuracies in the displayed data.
Manage All Your Safety Data Sheets with Sevron
Stop chasing outdated documents. Get instant access, automatic updates, and complete compliance visibility.