MICRO-FLO M9 ACTIVATOR
WTP
Micro-Flo M9 Activator is a hydrochloric acid-based chemical preparation for producing chlorine dioxide solutions in potable and industrial water treatment. The product carries a Danger signal word due to its severe corrosive properties that can cause skin burns and eye damage, requiring careful handling with appropriate personal protective equipment.
Hazard Pictograms
ghs057647-01-0
English
GHS/CLP
21 May 2013
Request This SDS
Safety Information
Key safety data extracted from the official Safety Data Sheet
Key Hazards
Danger- Causes severe skin burns and eye damage through direct contact
- Highly acidic with pH of 1-2, indicating strong corrosive potential
- Toxic to aquatic life at low concentrations (280 mg/l to rainbow trout)
- May cause respiratory irritation if exposure to vapors occurs
First Aid Quick Guide
Rinse cautiously with water for several minutes and remove contact lenses if present. Transfer to hospital for specialist examination immediately.
Wash immediately with soap and water. Remove contaminated clothing and seek medical advice if irritation persists.
Remove from exposure to fresh air. Transfer to hospital as soon as possible if breathing difficulties occur.
If conscious, give half a liter of water to drink immediately. Transfer to hospital without delay.
Protection Needed
Self-contained breathing apparatus must be available in case of emergency; use if vapors are generated.
Wear protective gloves (nitrile or rubber recommended) when handling concentrate.
Safety goggles required to prevent contact with splashes and aerosols.
Wear protective clothing to prevent splashing onto skin and body contact.
Physical Properties
Safe Handling
- Ensure sufficient ventilation of the work area to reduce vapor exposure
- Avoid all direct contact with skin and eyes during handling
- Turn leaking containers leak-side up to prevent liquid escape
- Keep container tightly closed when not in use
- Do not allow concentrated product to enter water sources or drains
Store in original container in a cool, well-ventilated area away from bases and incompatible materials.
Disclaimer: The information displayed on this page is derived from the manufacturer's Safety Data Sheet. Always refer to the official SDS document for complete and up-to-date safety information. Sevron is not responsible for any inaccuracies in the displayed data.
Manage All Your Safety Data Sheets with Sevron
Stop chasing outdated documents. Get instant access, automatic updates, and complete compliance visibility.