Activator ACT85
PPG Aerospace
Activator ACT85 is an industrial isocyanate-based catalyst mixture used in spray applications. This flammable liquid presents significant hazards including respiratory sensitization, skin and eye irritation, and potential organ damage from prolonged exposure. Proper ventilation, personal protective equipment, and careful handling procedures are essential.
Hazard Pictograms
ghs08
ghs07
ghs0228182-81-2,1330-20-7,108-65-6,100-41-4,822-06-0,108-88-3
English
GHS/CLP
21 December 2015
Request This SDS
Safety Information
Key safety data extracted from the official Safety Data Sheet
Key Hazards
Danger- Flammable liquid and vapor with flash point of 23°C
- Harmful if inhaled and may cause respiratory irritation or asthmatic symptoms
- Causes serious eye irritation and skin irritation
- May cause allergic skin reactions and respiratory sensitization
- May cause organ damage through prolonged or repeated exposure
First Aid Quick Guide
Immediately remove contact lenses if present. Rinse cautiously with clean water for at least 10 minutes and seek immediate medical attention.
Remove contaminated clothing and shoes. Wash skin thoroughly with soap and water or use recognized skin cleanser. Do not use solvents or thinners. Seek medical advice if irritation persists.
Remove to fresh air immediately. Keep person warm and at rest. If breathing is irregular or respiratory arrest occurs, provide artificial respiration or oxygen by trained personnel.
If swallowed, seek medical advice immediately and show the container or label. Keep person warm and at rest. Do NOT induce vomiting.
Protection Needed
By spraying: air-fed respirator required. For other operations in well-ventilated areas: combination charcoal and particulate filter mask acceptable. Selection based on anticipated exposure levels.
Chemical-resistant, impervious gloves such as butyl rubber complying with approved standards. Check gloves during use for continued protection.
Chemical splash goggles or safety glasses
Protective clothing including anti-static overalls, boots, and gloves when risk of static electricity exists. Select based on task and risks involved.
Physical Properties
Safe Handling
- Always use adequate ventilation or wear air-fed respirator when spraying
- Prohibit eating, drinking, and smoking in handling areas
- Do not get in eyes, on skin, or on clothing
- Avoid breathing vapor or mist
- Use only with adequate ventilation and explosion-proof electrical equipment
- Use non-sparking tools and take precautions against static electricity
Store at 5-35°C in original container protected from direct sunlight in a dry, cool, well-ventilated area away from incompatible materials. Keep container tightly closed and sealed. Store locked up. Separate from oxidizing materials, acids, amines, and alcohols.
Disclaimer: The information displayed on this page is derived from the manufacturer's Safety Data Sheet. Always refer to the official SDS document for complete and up-to-date safety information. Sevron is not responsible for any inaccuracies in the displayed data.
Manage All Your Safety Data Sheets with Sevron
Stop chasing outdated documents. Get instant access, automatic updates, and complete compliance visibility.